Skip header
ManualsContentsPreviousNextHelp

Replacing the Intermediate Transfer Unit

CAUTION

When to replace the intermediate transfer unit

Replace the intermediate transfer unit if any of the following messages appear on the display:

"Replace IntTrans Unit."

Illustration of message

  1. Turn off the power, and then unplug the power cable.

  2. Carefully open the left cover of the printer.

    Printer illustration

  3. Turn the two green levers of the inner cover anticlockwise (one), and then slowly open the inner cover (two).

    Printer illustration

  4. Carefully open the printer's front cover (A) by pulling the left and right side levers.

    Printer illustration

  5. Turn the green lever of the transfer unit counterclockwise to unlock the unit.

    Printer illustration

  6. Pull out the handle of the transfer unit. Grasp the handle and the green lever firmly, and then slowly pull out the transfer unit, until the green line marked on the upper surface of the unit appears.

    Printer illustration

    Do not touch any protruding areas on the transfer unit. These may stain your hands or clothes.

  7. When the green line appears, pull up the handles on the upper surface and support the transfer unit with your other hand.

    Printer illustration

  8. Grasp the raised up handles with both hands, and then pull the transfer unit completely out.

    Printer illustration

    • Use both hands and both handles when you pull out the unit.

    • Do not touch the belt area (underside) of the unit.

  9. Take the new transfer unit out of its box.

    Transfer unit illustration

  10. Hold both upper handles, and then slide the transfer unit along the guide rails into the printer.

    Printer illustration

    The upper handles must be raised to insert the unit.

  11. When the upper handles touch the printer body, lower the handles, and then push in the transfer unit, until it stops.

    Printer illustration

  12. Turn the green lever clockwise to lock the unit.

    Printer illustration

  13. Carefully close the front cover (A).

  14. Close the inner cover. Lock the inner cover by pressing in (one) and then turning the two green levers clockwise (two).

    Printer illustration

  15. Carefully close the left cover.

  16. Plug in the power cable, and then turn on the power.

    The printer starts calibration. Wait until it stops.

    Wait until "Ready" appears on the display panel.

    Do not turn off the power during calibration. Doing so results in malfunction.