Skip header
ManualsContentsPreviousNextHelp

Setting the Ethernet Speed

You can set the speed that the printer will use for Ethernet communications. In most cases, this should be left on the default setting, [Auto Select]. This setting allows two interfaces to automatically determine the optimum speed when they are connected.

Router/HUB

Printer

[10Mbps Half Duplex]

[10Mbps Full Duplex]

[100Mbps Half Duplex]

[100Mbps Full Duplex]

[Auto Select]

10 Mbps half duplex

active

-

-

-

active

10 Mbps full duplex

-

active

-

-

-

100 Mbps half duplex

-

-

active

-

active

100 Mbps full duplex

-

-

-

active

-

auto-negotiation (auto selection)

active

-

active

-

active

Important

  1. Press the [Menu] key.

    Control panel illustration

  2. Press the [Down arrow key] or [Up arrow key] key to select [Host Interface], and then press the [OK] key.

    Operation panel screen illustration

  3. Press the [Down arrow key] or [Up arrow key] key to select [Network], and then press the [OK] key.

    Operation panel screen illustration

  4. Press the [Down arrow key] or [Up arrow key] key to select [Ethernet Speed], and then press the [OK] key.

    Operation panel screen illustration

  5. Press the [Down arrow key] or [Up arrow key] key to select the Ethernet speed, and then press the [OK] key.

    Operation panel screen illustration

  6. Press the [Menu] key to return to the initial screen.

  7. Print a configuration page to confirm the settings.

Note