Specifying an IP Address (No DHCP)

Press the [Menu] key.

Press the [] or [] key to select [Host Interface], and then press the [OK] key.

Press the [] or [] to select [Network], and then press the [OK] key.

Press the [] or [] key to select [Effective Protocol], and then press the [OK] key.

Press the [] or [] key to select the appropriate network protocol, and then press the [OK] key.

Press the [] or [] key to select [Active] or [Inactive], and then press the [OK] key.

Set other protocols you need to set in the same way.

• Select [Inactive] for unused protocols.

• Enable IPv4 to use the pure IPv4 environment of NetWare5/5.1, Netware 6/6.5.

Press the [Escape] key until the screen returns to the [Network] menu.

If you use IPv4, assign the IPv4 address to the printer. Press the [] or [] key to select [Machine IPv4 Address], and then press the [OK] key.

To get the IP address for the printer, contact your network administrator.

To specify the IP Address, press [IP Add.].

If you use IPv4, also assign the subnet mask and gateway address. To assign these, press [Subnet M] or [Gateway].

Press the [] or [] to Enter the address, and then press the [OK] key.

Press the [] or [] key to enter the left-most entry field of the address. After entering the left field, press the [] key, and then you can enter the next field. After completing entry of the all fields, press the [OK] key.

Change the IP address from "11.22.33.44" to an IP address supported by your network.

Use the same method to assign the subnet mask and gateway address.

Press the [] or [] key to select [Specify], and then press the [OK] key.

If you do not select [Specify] in this step, the address you set will not be saved.

Press the [Menu] key to return to the initial screen.

Print a configuration page to confirm the settings.