Settings Required to Use LDAP Server

To use an LDAP server, you need to program it beforehand in LDAP Settings.

By registering the LDAP server, you can search the LDAP server's address book for an recipient's e-mail address when sending files by e-mail using the scanner or fax functions.

To use this function with GX 3000SF, the network interface board must be installed.

To execute LDAP Search, be sure to specify, “Server Name”, “Server Port No.”, “Search Base”, “User Name”, and “Password”.

The required setting depends on the server environment, so check the server environment and specify the setting accordingly. As for the other settings, check the server environment as required and specify the settings accordingly.

Server Name

User Name

Enter user name.

Password

Enter password.

The password is required for authentication to access the LDAP server.

Server Port No.

Specify the port number for communicating with the LDAP server.

Specify a port that matches your environment.

Search Timeout

Specify the maximum time to search the LDAP server's address book.

The time can be set from 5 to 60 seconds in 1 second increments, using the number keys. The default setting is 60 second(s).

Max. Results No.

Use the number keys to specify the maximum number of search results to display (10 to 100). The default setting is 100.

Search Base

Select a route folder to start the search. e-mail addresses registered in the selected folder are search targets.

Search base registration may be required depending on your server environment. When registration is required, unspecified searches will result in error. Check your server environment and enter any required specifications.

Search Condition

Specify the search criteria.

Begin
Include
End

The default setting is “Include”.