ContentsPreviousNext |
You can make network-related settings in Network Settings.
To use this function with GX 3000SF, the network interface board must be installed.
Be sure not to press the [YES] key for [Specify] in [Machn. IP Adress] if the machine is configured to obtain its IP address from a DHCP server. If you press [YES], the machine will use a static IP address. To cancel the static IP address, set [Machn. IP Adress] to [Auto] again.
Machn. IP Adress
You can specify the IP address.
Auto
Specify
Specify the machine's IP address using the number keys.
Default: 0.0.0.0
The default setting is “Auto”.
If you select [Specify], you must enter the subnet mask and gateway address as “xxx.xxx.xxx.xxx”.
(“x” indicates a number.)
Subnet Mask
You can specify the subnet mask.
Default: 0.0.0.0
Gateway Address
You can specify the gateway address.
Default: 0.0.0.0
DNS Settings
Make settings for the DNS server.
When you select [Active], enter the DNS server IP address as “xxx.xxx.xxx.xxx” (“x” indicates a number).
Default: Inactive
Ethernet Speed
Set the access speed for networks.
Select a speed that matches your network environment. [Auto Select] should usually be selected.
Auto Select
10Mbps Half Dup.
10Mbps Full Dup.
100Mbps Half Dup.
100Mbps Full Dup.
The default setting is “Auto Select”.
Reset Ethernet Bd
You can reinitialize the network interface board to reinstate its factory settings.