[09: Finishing: Fold]

Adjust the width of the bottom end segment (S) of Z-folded sheets when using the Paper Folding Unit.

Press [] to increase and [] to reduce (S).

The mark indicates the leading edge (relative to the paper feed direction), and the mark indicates the trailing edge.

Adjust the overall fold size (L) of Z- folded sheets when using the Paper Folding Unit.

Press [] to increase and [] to reduce (L).

The mark indicates the leading edge (relative to the paper feed direction), and the mark indicates the trailing edge.

Adjust the folding position when Folding in Two is done by the Paper Folding Unit. It applies when Single Folding is selected.

Adjust the folding position when Folding in Two is done by the Paper Folding Unit. It applies when Overlap Folding is selected.

Adjust the folding position on the front end side when Outside 3 Folding is done by the Paper Folding Unit. It is applied when Single Folding is selected.

Adjust the folding position on the front end side when Outside 3 Folding is done by the Paper Folding Unit. It is applied when Overlap Folding is selected.

Adjust the folding position on the rear end side when Outside 3 Folding is done by the Paper Folding Unit. It is applied when Single Folding is selected.

Adjust the folding position on the rear end side when Outside 3 Folding is done by the Paper Folding Unit. It is applied when Overlap Folding is selected.

Adjust the folding position on the front end side when Inside 3 Folding is done by the Paper Folding Unit. It applies when Single Folding is selected.

Adjust the folding position on the front end side when Inside 3 Folding is done by the Paper Folding Unit. It applies when Overlap Folding is selected.

Adjust the folding position on the rear end side when Inside 3 Folding is done by the Paper Folding Unit. It applies when Single Folding is selected.

Adjust the folding position on the rear end side when Inside 3 Folding is done by the Paper Folding Unit. It applies when Overlap Folding is selected.

*1 If the machine in use allows -0.1 mm or less to be selected, this will be interpreted as 0.0 mm.

Adjust the first folding position when Parallel Folding is done by the Paper Folding Unit.

Adjust the second folding position when Parallel Folding is done by the Paper Folding Unit.

Adjust the folding position on the front end side when Gate Folding is done by the Paper Folding Unit.

Adjust the folding position on the rear end side when Gate Folding is done by the Paper Folding Unit.

Adjust the center folding position when Gate Folding is done by the Paper Folding Unit.

Specify whether or not to automatically detect when the folding unit tray becomes full.

If you set this to [On], the machine detects when the folding unit tray becomes full and displays a warning message after printing the number of sheets specified in [Number of Sheets Folded after Full Detection].

Specify the number of sheets the machine prints when it detects that the folding unit tray is full before displaying a warning message.

By increasing the number of sheets printed, you can decrease warning messages, prevent the machine from stopping printing, and so increase throughput.

A multi-sheet fold copy is counted as a single sheet.

This setting becomes effective only if [Folding Unit Tray Full Detection] is set to [On].