User GuideIM 550/600 series

Programming the LDAP Server

You can search user information stored in the LDAP Server. Use it for the following purposes:

  • When you send files by e-mail under the Scanner or Fax function, you can search the Address Book stored in the server and specify the e-mail address.

  • Log in the machine using the Authentication Information registered in the server.

Note

1Log in to the machine as the machine administrator on the control panel.

2On the Home screen, press [Settings].

Operation panel screen illustration

3Press [Machine Features Settings].

Operation panel screen illustration

4Press [System Settings][Administrator Tools] tab [Program / Change / Delete LDAP Server] to display the LDAP Server Program screen.

5Press [Program / Change].

Operation panel screen illustration

6Press [*Not Programmed], and then enter the information for the LDAP Server.

Operation panel screen illustration
  • Name: Enter an optional program name. The name is to distinguish the server from another LDAP server.

  • Server Name: Enter the Host Name or IPv4 Address of the LDAP server.

  • Search Base: Select a root folder to start a search. E-mail addresses stored in this folder are search targets when files are sent using the Scanner or Fax function.

  • Port No.: Enter the port number used for the communication with the LDAP server.

  • Use Secure Connection (SSL): When set to [On], the port number is changed to 636.

    When set to [Off], security problems may occur.

    Encrypting Network Communication

  • Authentication: Select the authentication method according to the authentication settings of the LDAP server.

    • Kerberos Authentication: Authentication is performed on the KDC server. The password is protected with encryption and is then sent to the KDC server.

    • Digest Authentication: Authentication is performed on the LDAP server. This method is only available on a server supporting LDAP version 3.0. The password is protected with encryption and is then sent to the LDAP server.

    • Cleartext Authentication: The password is sent to the LDAP server without encryption.

    • Off: Select when server authentication is not required.

  • User Name, Password: Enter the user name and password of the account that requests Search to the LDAP server (administrator or representative). For the search request with the Authentication Information of the user, do not enter.

    • You can browse the Address Book instead of entering the user name and password directly.

  • Realm Name: If [Kerberos Authentication] is selected, select the Realm Name.

    Program the Realm in advance.

    Programming the Realm

7Press [Connection Test].

8After checking the connection with the LDAP server, set the search conditions or key display name.

Operation panel screen illustration
  • Search Conditions: Enter the attributes as keywords for search conditions, [Name], [Email Address], [Fax Number], [Company Name], or [Department Name] using up to 64 characters. Confirm and specify the server environment to be used. Because attributes are used for searching in the Address Book of the LDAP Server, a search is disabled if attributes are left blank.

  • Search Options: Specify [Attribute] and [Key Display] according to the server you are using.

    • Attribute: Enter the attribute for optional search conditions as necessary. For example, to search using the employee number, register "employeeNo" as an attribute. Once search options are stored, register the key display names.

    • Key Display: Enter the display name of the column in which search options are entered. For example, if the search option is the employee number, register "employeeNo".

9Press [OK].

10After completing the procedure, press [Home] (Operation panel screen illustration).

Note

  • To change/delete the stored LDAP server, display the [System Settings][Administrator Tools] tab [Program / Change / Delete LDAP Server] screen, press [Program / Change] or [Delete], and then select the LDAP Server Name.