Previous
Follow the procedure (a) " Resolving the problem according to the printed surface" first, and then follow the procedure (b) "Resolving the problem according to the cause".
(a) Resolving the problem according to the printed surface
Pull the extension tray out from the finisher shift tray, and attach the SR5000 series output tray for banner sheet.
In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators] menu, select 0632: [Output Fan Setting].
Is the sheet delivered with the printed side facing down?
Yes |
Select [Output Fan Setting] to [Off]. |
No |
Select [Output Fan Setting] to [On]. |
Print the image. Is the problem resolved?
Yes |
Finished! When all of the necessary printing is complete, configure [Output Fan Setting] back to [Auto]. |
No |
Proceed to the procedure (b) "Resolving the problem according to the cause". |
(b) Resolving the problem according to the cause
<Sheet end curling>
In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators] menu, select 0632: [Output Fan Setting] to [Off].
Print the image. Is the problem resolved?
Yes |
Finished! When all of the necessary printing is complete, configure [Output Fan Setting] back to [Auto]. |
No |
Go to the next step. |
Print on a smaller number of sheets. If the problem persists, configure [Output Fan Setting] back to [Auto] and contact your service representative.
<Sheet buckling>
Pull the extension tray out from the finisher shift tray, and attach the Z-fold support tray.
In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators] menu, select 0632: [Output Fan Setting] to [On].
Print the image. Is the problem resolved?
Yes |
Finished! When all of the necessary printing is complete, configure [Output Fan Setting] back to [Auto]. |
No |
Go to the next step. |
Print on a smaller number of sheets. If the problem persists, configure [Output Fan Setting] back to [Auto] and contact your service representative.
<Tip curling-up>
Is it possible to flip the printed side by delivering the paper inverted?
Yes |
Go to the next step. |
No |
Print on a smaller number of sheets. If the problem persists, configure 0632: [Output Fan Setting] back to [Auto] and contact your service representative. |
Press [Output/ Customize Function/ Finisher].
Press [Output/ Cstmz.].
Press [Rvrse Ejct: FaceUp/Dn].
Press [OK].
Print the image. Is the problem resolved?
Yes |
Finished! |
No |
Go to the next step. |
In [Advanced Settings] for your custom paper being used, adjust the feed speed for the decurler unit.
Print the image. Is the problem resolved?
Yes |
Finished! |
No |
Go to the next step. |
Print on a smaller number of sheets. If the problem persists, configure 0632: [Output Fan Setting] back to [Auto] and contact your service representative.
For details about how to attach the thin paper support tray or the Z-fold support tray, see "Guide to Functions of the Machine's Options", Preparation.
