Top Page > Troubleshooting: TCRU/ORU > Post-Processing Option Troubleshooting > Finisher SR5110/Booklet Finisher SR5120 > Trailing edge of stapled sheets close to the paper exit > Solution:

Solution:

Previous Next

Attach the Z-fold support tray for multi-folding unit.

Print the image. Is the problem resolved?

Yes	Finished!
No	Go to the next step.

In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set 0310: [Correct Output Paper Curl] to "U Curl Correction Level".

Select "Large" or "Small" to control the level of decurling as required.

Print the image. Is the problem resolved?

Yes	Finished!
No	Contact your service representative.

For details about attaching the Z-fold support tray for multi-folding unit, see "Preparation" supplied with the machine.
If the Z-fold support tray for multi-folding unit is attached, the trailing edge of the ejected sheets will not be too close to the paper exit, so no problem will occur. However, the stapled sheets may not be stacked properly.