Previous
Depending on the cause of the problem, do one of the following:
<Sheet bending>
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
<If the decurler unit is used>
In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set 0310: [Correct Output Paper Curl] to "U Curl Correction Level".
To control the level of decurling, select "Small" if the present setting is "Off" or "Large" if the present value is "Small".
<If the decurler unit is not used>
Load the sheets the other way up.
Paper of Paper Weight 0 is being used.
If paper of Paper Weight 0 is being used, attach the Z-fold support tray for multi-folding unit.
For details about attaching the Z-fold support tray for multi-folding unit, see "Preparation" supplied with the machine.
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set 0310: [Correct Output Paper Curl] to "П Curl Correction Level".
To control the level of decurling, select "Small" if the present setting is "Off" or "Large" if the present value is "Small".
<If the decurler unit is not used>
Set the reverse side of the paper.
Print the image. Is the problem resolved?
Yes
Finished!
No
Go to the next step.
In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators] menu, set 0633: [Output Fan Level] to [Increase Air Volume].
Print the image. Is the problem resolved?
Yes
Finished!
When all of the necessary printing is complete, configure [Output Fan Level] back to [Standard].
No
Contact your service representative.
Paper of Paper Weight 0 is being used.
If paper of Paper Weight 0 is being used, attach the Z-fold support tray for multi-folding unit.
For details about attaching the Z-fold support tray for multi-folding unit, see "Preparation" supplied with the machine.
