Previous
Depending on the cause of the problem, do one of the following:
<Sheet bending>
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
<If the decurler unit is used>
In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set 0310: [Correct Output Paper Curl] to "U Curl Correction Level".
To control the level of decurling, select "Small" if the present setting is "Off" or "Large" if the present value is "Small".
<If the decurler unit is not used>
Load the sheets the other way up.
Paper of Paper Weight 0 is being used.
If limp paper such as thin paper is being used, set the finisher upper tray to the paper output tray.
If paper is not loaded correctly even if the finisher upper tray is being used, attach the support tray.
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
In the [Main Unit: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set 0310: [Correct Output Paper Curl] to "П Curl Correction Level".
To control the level of decurling, select "Small" if the present setting is "Off" or "Large" if the present value is "Small".
Attach the output jogger.
<If the decurler unit is not used>
Set the reverse side of the paper.
Attach the output jogger.
