Heat Roller Temp
Adjust the temperature of heat roller.
Press [] to increase the temperature and [] to reduce it.
Decreasing the temperature too much may cause the toner to not properly fuse to the paper (cold offset).
Increasing the temperature too much may distort the paper and cause glossy lines, paper jams, and insufficient toner fusing (hot offset).
Depending on the type of paper, you can increase the toner gloss by increasing the temperature by 5 to 10°C over the initial factory setting.
Corct Temp: Initial Feed / Corct Temp: Pre-Feed
Adjust the temperature to be added at the beginning of the paper feed.
Press [] to increase the temperature and [] to reduce it.
Setting Item |
Max. Value |
Min. Value |
Step |
Unit |
---|---|---|---|---|
01: Heat Roller Temp |
200 |
100 |
1 |
deg |
02: Corct Temp: Initial Feed/03: Corct Temp: Pre-Feed |
30 |
0 |
1 |
deg |