User GuideIM 350/430 series

Printing text and serial numbers (classic)

Illustration of Stamp Text

Before using this function, select [On] under [Change Job Serial No. for First Job] in User Tools. For details about [Change Job Serial No. for First Job], see Stamp Text (Copier / Document Server Features).

Important

  • You cannot use the bypass tray with this function.

1Press [Edit / Stamp].

Operation panel screen illustration

2Press [Stamp] twice.

3Press [Stamp Text].

Operation panel screen illustration

4Press [Change Text].

5Enter stamp text, and then press [OK].

Stamps may consist of up to 55 alphanumeric characters and symbols, and a numeric series of up to 9 digits for a total of 64 characters.

6Press [Change Start No.].

7Enter a number from which to start numbering, and then press [Sharp].

The number is displayed in nine digits. If you enter "1", the number is printed as "000000001".

8Press [OK].

9Press [Change] under [Stamp Position].

10Select the stamp position, and then press [OK].

Operation panel screen illustration

11Press [OK] three times.

Note

  • When Auto Clear is done, [Reset] is pressed, or the power is turned off, the text is cleared and the next number in the sequence is displayed.

  • This function cannot be used for the Job Preset or Interrupt Copy function. Also, this function cannot be used to print stored documents.

  • If this function is used with the Combine function, a print image may differ according to the [Page Numbering in Combine] settings under [Page Numbering]. For details, see Page Numbering.

  • For details about Stamp Text, see Stamp Text.