Previous
Conditions where fold function will be canceled
Fold function will be canceled when:
Paper size or type which is not compatible with the fold function is selected.
The machine is made to continue printing manually.
[Auto Continue] is set.
A paper type on which Multi-sheet Fold cannot be applied is selected.
Multi-sheet Fold is specified but the paper sizes are different.
Multi-sheet Fold is specified but the number of sheets exceeds the maximum number available for the fold function.
A combination of paper orientation and fold position that cannot be folded is selected.
Paper is fed from an optional interposer.
Multi-folding unit is not installed.
Functions that will cause job reset to occur when combined with the fold function
Slip Sheets*1
Separation Sheets*1
Staple*2
Punch
Ring Binding
Perfect Binding
Half Fold configured on the Booklet Finisher
*1 Job reset occurs only when combined with Half Fold, Letter Fold-in, Letter Fold-out, Double Parallel, or Gate Fold.
*2 Job reset occurs only when combined with Half Fold, Letter Fold-in, Letter Fold-out, Double Parallel, or Gate Fold. It can be specified along with Z-fold except when Staple (Center) is selected (using the Booklet Finisher).
Functions that will be canceled when combined with the fold function
The following functions will be canceled when specified with Booklet Binding at the same time:
Stack
Extended Auto Tray Switching
Ejecting paper with the printed side facing up
If the information icon (
/ 
) is displayed next to the "Fold:" list, you cannot specify fold function. Click the information icon ( / ) to check why fold function is unavailable.If you cannot make fold function settings even with a multi-folding unit installed, options may not be set correctly in the printer driver. To correct the printer driver's option settings, see "Specifying the Option Configuration or Paper Settings Manually", Driver Installation Guide.
When stapling Z-folded paper, fewer sheets than normal can be stapled together. This is because a single Z-folded sheet is equivalent to 10 non-Z-folded sheets. For the number of sheets that can be stapled, see "Specifications for Finisher SR5110" or "Specifications for Booklet Finisher SR5120", Specifications.
Depending on the temperate and humidity conditions of the machine's environment and the type of paper being folded, use of the fold function can cause toner smearing, which can occasionally result in spoilt prints.
Wrinkling can occur when applying letter fold-out to B4 JIS
, A3, 81/214, 11 × 17, 8K, or larger sheets. In some cases, you may have to use A4 sheets or smaller when applying folds in combination with the reduction function.Print quality over fold lines might be reduced. This is due to cracking within the fused toner. Loss of surface along fold lines can also occur with some types of paper. To avoid possible wastage, print a single test sheet before beginning a print run.
Printing will stop if the number of printed sheets exceeds tray capacity. If this happens, remove printed sheets from the folding unit tray to resume printing.
