Margin Adjustment

When [Synchro Cut] is selected, you can create a margin on the copy's leading and trailing edge.

Important

  • You cannot use the paper bypass location with this function.

This function has the following two types:

  • Top Margin
    Add a margin to the leading edge at the top of the copy.
    Illustration of Margin Adjustment

  • Bottom Margin
    Add a margin to the trailing edge at the bottom of the copy.
    Illustration of Margin Adjustment

  1. Press [Edit / Color].
    Operation panel screen illustration

  2. Press [Margin Adj.].

  3. Press [Top Margin].

  4. Specify the margin using [Plus] or [Minus].

  5. Press [Bottom Margin].

  6. Specify the margin using [Plus] or [Minus], and then press [OK].
    [Synchro Cut] is automatically selected.

Note

  • Pressing [Plus] or [Minus] changes the width in increments of 1 mm (0.1 inches). Pressing and holding down the relevant key changes the width in increments of 10 mm (1 inch).

  • You can specify the margin from 0 to 200 mm (0 to 7.9 inches).

  • You can specify both the top and the bottom margins at a time.

  • The length of a copy is a combined length of an original and its margins. The length of an original is automatically specified in the Synchro Cut mode.

  • If you specify the margin too long for the original, parts of the image might not be copied.

  • You can change the settings for Margin Adjustment under [Margin Adjustment Priority]. For details, see User Guide of your device.

x

QR Code