Punch

You can make punch holes in copies.

Original orientation and punch hole position

Place all the originals in the ADF in the orientation in which they can be read normally. When placing the original on the exposure glass, keep the same orientation, but place the original facing downwards.

When the paper that is loaded is the same size and orientation as the original, the relationship between the orientation in which you place the original and the punch hole positions is as follows. You can confirm the punch hole positions that can be selected on the screen that appears when [Finishing] is pressed.

	Placing the original on the exposure glass	Placing the original in the ADF	Punch hole position*1
2 Holes Left
2 Holes Top
3 Holes Left
3 Holes Top
4 Holes Left
4 Holes Top

*1 The above table shows punch hole positioning. Punched sheets might not be delivered in the orientation shown in this table.

*2 You cannot punch holes in this position when copying onto B4 JIS, 8 × 13 or larger.

*3 If you want to punch holes in this position, select unreadable orientation in [Original Orientation], and then select the punch hole position.

1. Press [Finishing].
   

2. Press [Finisher].

3. Select one of the punch hole positions.
   

4. Press [OK].

5. Enter the number of copy sets with the number keys.

6. Place the originals, and then press [Start].