Previous
Depending on the cause of the problem, do one of the following:
<Sheet bending>
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Sheets are curled upward.
<If the decurler unit is used>
In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, select 0301: [Correct Output Paper Curl: 1 Sided: Face Up], 0302: [Correct Output Paper Curl: 1 Sided: Face Down], or 0303: [Correct Output Paper Curl: 2 Sided], and then specify "П Curl Correction Level".
If "Off" is selected, change the value to "Small". If "Small" is selected, change the value to "Medium". If "Medium" is selected, change the value to "Large".
<If the decurler unit is not used>
Load the sheets the other way up.
Coated paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0662: [Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0660: [Output Trail Edge Press Setting] to [On].
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0661: [Output Fan Setting] to [On].
Paper of Paper Weight 0 is being used.
If paper of Paper Weight 0 is being used, attach the banner support tray.
For details about attaching the banner support tray, see "Preparation" supplied with the machine.
<One sheet pushing out another or sheets becoming crimped>
Sheets are curled downward.
<If the decurler unit is used>
In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, select 0301: [Correct Output Paper Curl: 1 Sided: Face Up], 0302: [Correct Output Paper Curl: 1 Sided: Face Down], or 0303: [Correct Output Paper Curl: 2 Sided], and then specify "П Curl Correction Level".
If "Off" is selected, change the value to "Small". If "Small" is selected, change the value to "Medium". If "Medium" is selected, change the value to "Large".
<If the decurler unit is not used>
Set the reverse side of the paper.
Print the image. Is the problem resolved?
Yes
Finished!
No
Go to the next step.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0662: [Output Fan Level] to [Increase Air Volume].
Print the image. Is the problem resolved?
Yes
Finished!
When all of the necessary printing is complete, configure [Output Fan Level] back to [Standard].
No
Contact your service representative.
Coated paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0662: [Output Fan Level] to [Increase Air Volume].
Standard paper is being used.
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0660: [Output Trail Edge Press Setting] to [On].
In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0661: [Output Fan Setting] to [On].
Paper of Paper Weight 0 is being used.
If paper of Paper Weight 0 is being used, attach the banner support tray.
For details about attaching the banner support tray, see "Preparation" supplied with the machine.
