Solution:

Depending on the cause of the problem, do one of the following:

<Sheet bending>

There is airflow in the room.

Minimize the airflow. For instance, turn the air conditioner off.

Sheets are curled upward.

  1. Load the sheets the other way up.

  2. Print the image. Has the problem been resolved?

    Yes

    Finished!

    No

    Go to the next step.

  3. In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, select 0301: [Correct Output Paper Curl: 1 Sided: Face Up], 0302: [Correct Output Paper Curl: 1 Sided: Face Down], or 0303: [Correct Output Paper Curl: 2 Sided], and then specify "U Curl Correction Level".

    Alternatively, in [Advanced Settings] for the custom paper, select 1311: [Correct Paper Curl], and then specify "U Curl Correction Level".

    If "Off" is selected, change the value to "Small". If "Small" is selected, change the value to "Medium". If "Medium" is selected, change the value to "Large".

Coated paper is being used.

In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0617: [Output Fan Level] to [Increase Air Volume].

Standard paper is being used.

  1. In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0615: [Output Trail Edge Press Setting] to [On].

  2. In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0616: [Output Fan Setting] to [On].

<One sheet pushing out another or sheets becoming crimped>

Sheets are curled downward.

  1. Load the sheets the other way up.

  2. Print the image. Has the problem been resolved?

    Yes

    Finished!

    No

    Go to the next step.

  3. In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, select 0301: [Correct Output Paper Curl: 1 Sided: Face Up], 0302: [Correct Output Paper Curl: 1 Sided: Face Down], or 0303: [Correct Output Paper Curl: 2 Sided], and then specify "П Curl Correction Level ".

    Alternatively, in [Advanced Settings] for the custom paper, select 1311: [Correct Paper Curl], and then specify "П Curl Correction Level".

    If "Off" is selected, change the value to "Small". If "Small" is selected, change the value to "Medium". If "Medium" is selected, change the value to "Large".

Coated paper is being used.

In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0617: [Output Fan Level] to [Increase Air Volume].

Standard paper is being used.

  1. In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0615: [Output Trail Edge Press Setting] to [On].

  2. In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0616: [Output Fan Setting] to [On].

PreviousNext