Solution:

Depending on the cause of the problem, do one of the following:

Coated paper is being used.

In the 06: [Finishing: Finisher] group on the [Adjustment Settings for Operators] menu, set 0617: [Output Fan Level] to [Increase Air Volume].

There is airflow in the room.

Minimize the airflow. For instance, turn the air conditioner off.

Printed sheets are curled.

  1. Load the sheets the other way up.

  2. Print the image. Has the problem been resolved?

    Yes

    Finished!

    No

    Go to the next step.

  3. In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, select 0301: [Correct Output Paper Curl: 1 Sided: Face Up], 0302: [Correct Output Paper Curl: 1 Sided: Face Down], or 0303: [Correct Output Paper Curl: 2 Sided], and then adjust the degree of decurling.

    To correct curls facing up, specify "U Curl Correction Level".

    To correct curls facing down, specify "П Curl Correction Level".

Select "Strong", "Medium" or "Weak" depending on the degree of decurling required.

There are too many stacked sheets.

Reduce the number of the stacked sheets. To do this, suspend printing and remove the stacked sheets, and then resume printing.

To suspend printing, press the [Suspend/Resume] key on the finisher.

To resume printing, press the [Suspend/Resume] key on the finisher.

Thin coated paper is used.

When stapling thin coated paper, the stapled sheets may be scratched or they may jam.

In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set 0301: [Correct Output Paper Curl: 1 Sided: Face Up], 0302: [Correct Output Paper Curl: 1 Sided: Face Down], or 0303: [Correct Output Paper Curl: 2 Sided] to "П Curl Correction Level". To control the level of decurling, select "Small" if the present setting is "Off", "Medium" if the present value is "Small", or "Large" if the present value is "Medium".

PreviousNext