Skip header
 

When using the staple function on thin coated paper weighing 80 g/m2 or less

When using the staple function on thin coated paper weighing 80 g/m2 or less, attach the two paper strengthening ribs to the staple tray.

The paper strengthening ribs are not supplied. To use the paper strengthening ribs, contact the service representative.

Important

  • When using the staple function on paper other than thin coated paper weighing 80 g/m2 or less, remove the paper strengthening ribs, and then set [Staple Tray: Rib Installed Mode to Strengthen Paper] in [Adjustment Settings for Operators] to [Off].

  • Attach the paper strengthening ribs also if paper jam occurs inside the staple tray.

1Open the finisher front cover.

2Holding the Rb12 handle, pull out the staple unit.

3Holding the paper strengthening rib horizontally, insert it into the area as shown.

Staple unit illustration

4Rotate the paper strengthening rib to a vertical orientation.

Staple unit illustration

5Insert the protrusions (2 parts) of the paper strengthening rib into the holes in the staple tray.

Staple unit illustration

Attach the paper strengthening rib with its cutout facing out.

Paper strengthening ribs illustration

6Attach the second paper strengthening rib. Repeat Steps 3 to 5.

7Set [0666 Staple Tray: Rib Installed Mode to Strengthen Paper] in [Adjustment Settings for Operators] to [On].