Skip header
 

Using telnet

Follow the procedure below to use telnet.

Important

  • Only one user at a time can log in to perform remote maintenance.

  • If you are using Windows 7/8.1/10, you must enable the telnet server and telnet client beforehand.

1Use the IP address or the host name of the machine to start telnet.

% telnet "IP address"

For example, if the machine's IP address is <192.168.15.16>, enter the address as follows:

% telnet 192.168.15.16

2Enter your user name and password.

For details about the user name and password, consult your network administrator.

3Enter a command.

4Quit telnet.

msh> logout

A message asking you to confirm saving the changes appears.

5Enter "yes" to save the changes, and then press the [Enter] key.

If you do not want to save the changes, enter "no", and then press the [Enter] key. To make further changes, enter "return" at the command line, and then press the [Enter] key.

Note

  • If the message "Can not write NVRAM information" appears, the changes are not saved. Repeat the procedure above.

  • When the changes are saved, the network interface board is reset automatically with those changes.

  • When the network interface board is reset, the print job in print process will be printed. However, print jobs in queue will be canceled.