Previous
You can install a 250-sheet paper feed unit or a 500-sheet paper feed unit.
|
Do not place the machine directly on the floor.
Turn the machine off and unplug the power cord.
Remove the packaging from the paper feed unit.
Lift the machine using the inset grips on both sides of the machine.
Be sure two people lift the machine.
When moving the machine, do not hold the following parts. Doing so may cause them to break.
The handle on the standard paper tray
The underside of the bypass tray
ADF
There are three upright pins on the optional paper feed unit. Align them with the holes on the underside of the machine, and then carefully lower the machine.
Plug in the power cord, and then turn on the machine.
Print the configuration page to confirm that the unit was attached correctly.
To check whether the optional paper feed unit was correctly attached, print the configuration page, and check "Attached Equipment" on the configuration page. If the unit was attached correctly, "Tray 2" will appear.
For information about printing the configuration page, see Test Printing.
If the optional paper feed unit was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after trying the installation a second time, contact your sales or service representative.
To use the paper feed unit, configure the machine options in "Accessories" in the printer driver. For details about opening "Accessories", see "Configuring Option Settings for the Machine ", Setup Guide.
