Skip header
 

Scanning Two-Sided Originals

Use this function to scan the front and back side of two-sided originals page by page.

You must place originals into the ADF when using this function. The exposure glass cannot be used with this function.

How to specify the orientation and page opening orientation settings

To transmit the original so that its front and back sides can be printed in the same orientation, configure [Original Orientation] and [Original Settings] according to the orientation of the original to be placed.

Unless [Original Orientation] and [Original Settings] are configured properly, the orientation of the front and back sides of the original may be in reverse when printed at the destination.

Original

Original position

Original Orientation

Original Settings

Illustration of two-sided originals

Illustration of two-sided originals

2 Sided: Open to Right/Left

Illustration of two-sided originals

Illustration of two-sided originals

2 Sided: Open to Top

Illustration of two-sided originals

Illustration of two-sided originals

2 Sided: Open to Right/Left

Illustration of two-sided originals

Illustration of two-sided originals

2 Sided: Open to Top

1Press [Original Orientation].

2Specify the original orientation.

Select the [Readable Direction] or [90 Degrees Counterclockwise] according to the orientation in which you place the original.

3Press [].

4Press [Original Settings].

5Select [2 Sided: Open to Right/Left] or [2 Sided: Open to Top].

Note

  • For details about acceptable original size and paper thickness for two-sided scanning with the ADF, see "Supported Original Sizes and Weights", Paper Specifications and Adding Paper.