Skip header
 

Cleaning the LED Heads

CAUTION

  • The inside of the machine could be very hot. Do not touch the parts with a label indicating the "hot surface". Otherwise, an injury might occur.

  • Some of this machine’s components get damaged on contact. Do not touch the sensors, connectors, or other fragile parts that are shown in this manual. Otherwise, a malfunction might occur.

Printer illustration

1Turn off the printer and unplug the power cord.

2Pull the top cover open lever upward to open the top cover.

Printer illustration

3Pull the inner cover open lever to unlock the inner cover, and then fully open the inner cover.

Printer illustration

4Wipe the lens of the LED heads softly with an LED lens cleaner.

There are four LED heads.

Raising the LED head at the bottom (4) with your hand makes it easier to clean it.

Be careful not to touch the LED lens surface with your fingers.

Printer illustration

5Close the inner and top covers with both hands carefully.

Printer illustration

6Securely insert the plug of the power cord into the wall socket. Connect all the interface cables that were removed.

7Turn the main power switch on.

PreviousNext