Output Tray Settings

PreviousNext

This section describes the output tray settings.

• Depending on the options installed on the machine, some trays might not be displayed.

  • When Finisher SR3210 or Finisher SR3230 is installed, [Finisher Shift Tray] and [Finisher Upper Tray] are displayed.

  • When the Internal Multi-Folding unit is installed, [Folding Unit Tray] is displayed.

  • When the mailbox is installed, [Mailbox Tray 1]–[Mailbox Tray 4] are displayed.

• If you select a setting that uses the finisher, the job might not be delivered to the specified output tray.

  • If you select stapling or punching, the job will be delivered to the finisher upper tray or the finisher shift tray.

  • If you select shift-sorting, the job will be delivered to the finisher shift tray.

  • You cannot interrupt the current stapling job even if a stapling job is specified by a different function.