Previous
This section explains how to specify a custom size for scanning the entire area of an original. If you want to scan the entire area of a custom size original, select [Custom Size] as the scan size.
To display the custom size setting screen, on the initial scanner screen, press [Scan Settings] > [Scan Size] > [Custom Size].
The following table explains how to measure custom size originals and how to specify the scan settings on the custom size setting screen.
How to measure sizes
Orientation and placement of original |
Measuring method for scanning the entire area of a custom size original |
|---|---|
In the |
|
In the |
|
orientation on the exposure glass or in the ADF
orientation on the exposure glass or in the ADF
Scan settings on the custom size setting screen
Original Size (X)
Specify the length of the original.
Enter the actual length in [X] then press [
].Original Size (Y)
Specify the width of the original.
Enter the actual width in [Y] then press [
].
For X and Y, you can specify 10 mm (0.4 inches) or larger.
For details about how to place originals, see Setting of Original Feed Type.
