Skip header
 

Solution:

Adjust the leading/trailing edge margins.

1In [Advanced Settings] for the custom paper in use, reduce the value by 0.5 mm in [Adjust Erase Margin of Leading Edge].

2Reduce the value by 0.5 mm in [Adjust Erase Margin of Trailing Edge].

3Print the image. Is the problem resolved?

Yes

Finished!

No

If this results in a paper jam during duplex printing, restore the previous setting.

Note

  • The adjusted margin cannot be applied to masked images that are solid-filled or contain ruled lines at the leading/trailing edges.

  • Reducing the leading/trailing edge margin may result in a paper jam on the fusing belt stripper plate.

PreviousNext