Skip header
 

When the Printed Color Changes

Color gradation during color printing can change slightly, depending on a number of factors. If you print the same file repeatedly or toner was recently replaced, changes may occur in color tones. In such cases, you can obtain optimal print results by correcting the color gradation.

You can set this menu when you log in as an administrator.

Note

  • Color gradation correction is not required under normal circumstances.

  • If a printer is not used for some time, changes can occur in color tones.

  • If suitable results cannot be obtained after a single correction, repeat the correction several times as needed.

  • Corrections to color gradation will be applied to all user jobs.

  • Use the same type of paper when printing a run of gradation corrections. If a different type of paper is used, corrections may not be apparent.

  • This feature requires the use of the supplied Color Calibration Sample Sheet.

  • Corrections to color gradation are performed in the following order:

    1. Print gradation correction sheet 1.

    2. Adjust the parts of highlight colors.

      Set the correction value.

      Print the gradation correction sheet, and then check the result of the correction.

    3. Print gradation correction sheet 2.

      Adjust the parts of middle colors.

      Set the correction value.

      Print the gradation correction sheet, and then check the result of the correction.

    4. Save the correction value.