Skip header
 

Notes on configuring the Half Fold function

Conditions to reset a job combined with the Half Fold function

A job is reset if:

  • The machine is configured to continue printing manually.

  • [Auto Continue] is specified.

  • [Driver / Command] is selected in [Tray Setting Priority] for the specified source tray.

  • Slip Sheets is specified.

  • The staple function is specified.

  • The punch function is specified.

  • The machine is printing a report.

  • The half fold function cannot be used for the selected paper size or type.

  • [Half Fold: Multi-sheet fold (Finisher Booklet Tray)] is specified but the paper sizes are different.

  • No requirements for specifying collate are fulfilled.

  • Booklet Finisher is malfunctioning.

  • Booklet Finisher is not installed.

Note

  • If the information icon (Icon illustration) is displayed next to the "Fold:" list, you cannot specify Half Fold function. Click the information icon (Icon illustration) to check why Half Fold function is unavailable.

PreviousNext