Follow the procedure below to set the printer to receive an IP address automatically using DHCP. The DHCP feature is active by default, so this procedure is only required if you have changed the default settings.
When [Auto-Obtain (DHCP)] is selected, you cannot configure the IP address, subnet mask, or gateway address.
Press [Home] () at the bottom of the screen in the center.
Flick the screen to the left, and then press the [User Tools] icon ().
Press [Machine Features].
Press [System Settings].
Press [Interface Settings].
Press [Machine IPv4 Address].
Press [Auto-Obtain (DHCP)].
Press [OK].
Press [Print List] to confirm the settings.
Press [User Tools] () on the top right of the screen.
Press [Home] () at the bottom of the screen in the center.