When installing multiple options, the following order is recommended:
Attach the lower paper tray.
The lower paper tray can be used in combination with the lower paper trays. In this case, attach the lower paper tray to the lower paper trays before attaching to the printer.
Attach the lower paper trays or Tray 3 (LCT).
Either the lower paper trays or Tray 3 (LCT) can be attached, but not both.
Attach the large capacity tray (LCT).
The lower paper trays or Tray 3 (LCT) must have been attached.
To attach this option, contact your sales or service representative.
Install the HDD.
For the Type 1 model, install the HDD on the controller board. The Type 2 model comes equipped with a HDD.
Install the interface board.
Install in the slot of the controller board.
Only one interface board can be installed.
Insert SD card options.
Insert in the SD card slot of the controller board.
There are two slots for SD cards.
Each slot supports different types of SD cards.
If you want to use two or more SD cards that can be inserted in the same slot, contact your sales or service representative.
Attach the bridge unit.
To attach this option, contact your sales or service representative.
Attach Booklet Finisher SR3220 or Finisher SR3230.
Either the Booklet Finisher SR3220 or Finisher SR3230 can be attached, but not both.
The bridge unit and the lower paper trays or Tray 3 (LCT) must have been attached.
To attach this option, contact your sales or service representative.
Attach the punch unit to the finisher.
To attach this option, contact your sales or service representative.
Attach the output jogger unit to Finisher SR3230.
To attach this option, contact your sales or service representative.
Attach Mailbox.
To attach this option, contact your sales or service representative.