Use Web Image Monitor to configure the security settings shown in the following table.
Category | Item | Setting |
---|---|---|
Device Settings | Collect Job Logs | Active |
Device Settings | Collect Access Logs | Active |
Security | Lockout | Active For details, see User Lockout Function. |
Security | Number of Attempts before Lockout | 5 times or less. For details, see User Lockout Function. |
Security | Lockout Release Timer | Set to [Active] or [Inactive]. When setting to [Active], set the Lockout release timer to 60 minutes or more. For details, see User Lockout Function. |
Security | Lock Out User for | When setting "Lockout Release Timer" to [Active], set the Lockout release timer to 60 minutes or more. For details, see User Lockout Function. |
Network | SNMPv3 Function | Inactive To use SNMPv3 functions, set "SNMPv3 Function" to [Active], and set "Permit SNMPv3 Communication" to [Encryption Only]. Because SNMPv3 enforces authentication for each packet, Login log will be disabled as long as SNMPv3 is active. |
Security | FTP | Inactive Before specifying this setting, set "Network Security Level" to [Level 2] on the control panel. |
Security | S/MIME | "Encryption Algorithm": AES-128 bit, AES-256 bit, or 3DES-168 bit You must register the user certificate in order to use S/MIME. |
Category | Item | Setting |
---|---|---|
Address Book | User Certificate | You must register the user certificate in order to use S/MIME. |
The administrator must indicate the strength level that can be specified for the encryption algorithm.
For details about specifying an encryption algorithm and registering a user certificate, see Configuring S/MIME.