Previous
You can make punch holes in copies.
Original orientation and punch hole position
Place all the originals in the ADF in the orientation in which they can be read normally. When placing the original on the exposure glass, keep the same orientation, but place the original facing downwards.
When the paper that is loaded is the same size and orientation as the original, the relationship between the orientation in which you place the original and the punch hole positions is as follows. You can confirm the punch hole positions that can be selected on the screen that appears when [Finishing] is pressed.
Original orientation
| Original orientation
| Original orientation
| Original orientation
| Punch hole position*1 | |
|---|---|---|---|---|---|
2 Holes Left
|
|
|
|
|
|
2 Holes Top
|
|
|
|
|
|
3 Holes Left
|
|
|
|
|
|
3 Holes Top
|
|
|
|
|
|
4 Holes Left
|
|
|
|
|
|
4 Holes Top
|
|
|
|
|
|
*1 The above table shows punch hole positioning. Punched sheets might not be delivered in the orientation shown in this table.
*2 You cannot punch holes in this position when copying onto B4 JIS, 8 × 13 or larger.
*3 If you want to punch holes in this position, rotate and place the originals, and then select the punch hole position.
When Using the Copy Application
About how to use the application's screen, see "[Copy] Screen".
When Using the Copier (Classic) Application
For details about how to use the Classic Copier function, see Procedure for Punch (classic).
