Previous
Message |
Status |
|---|---|
“Calibrating...” |
The printer is calibrating the color. Wait a while. |
“Hex Dump Mode” |
In Hex Dump mode, the printer receives data in a hexadecimal format. Press [Job Reset] to cancel Hex Dump mode. |
“Job suspended.” |
Printing was temporarily suspended because [Job Operation] or the [Suspended] key was pressed. |
“Loading Toner...” |
The printer is loading the toner. Wait a while. |
“Offline” |
The printer is offline. |
“Please wait.” |
This message might appear for a second or two while the printer is preparing, performing initial adjustments, or adding toner. Wait a while. |
“Printing...” |
The printer is printing. Wait a while. |
“Ready” |
This is the default ready message. The printer is ready for use. No action is required. |
“Resetting job...” |
The printer is resetting the print job. Wait until “Ready” appears on the display panel. |
“Setting change...” |
The printer is changing settings. You cannot use the control panel while this message is displayed. Wait a while. |
“Updating certif...” |
The @Remote certificate is being updated. Wait a while. |
“Waitg. for prt.data” |
The printer is waiting for the next data to print. Wait a while. |
