Skip header
 

Receiving an IP address automatically (DHCP)

Follow the procedure below to set the printer to receive an IP address automatically using DHCP. The DHCP feature is active by default, so this procedure is only required if you have changed the default settings.

Important

  • When [Auto-Obtain (DHCP)] is selected, you cannot configure the IP address, subnet mask, or gateway address.

1Press the [User Tools] key, and then display the [Network] screen.

[System Settings] [Interface Settings] [Network]

2Enable IPv4 protocol, and then specify the IPv4 address.

  • [Effective Protocol]

    Enable IPv4 protocol.

    Press [Active] under "IPv4" [OK]

  • [Machine IPv4 Address]

    Specify the printer's IPv4 address.

    [Auto-Obtain (DHCP)] [OK]
PreviousNext