Skip header
 

Specifying an IP address (no DHCP)

If you want to use the printer on a network without using DHCP or want to use a static IP address, use the following procedure to assign a specific IPv4 address to the printer. Before making any changes, contact your network administrator to obtain the IP address, subnet mask, and gateway address to be specified on the printer.

1Press the [User Tools] key, and then display the [Network] screen.

[System Settings] [Interface Settings] [Network]

2Enable IPv4 protocol, and then specify the IPv4 address.

  • [Effective Protocol]

    Enable IPv4 protocol.

    Press [Active] under "IPv4" [OK]

  • [Machine IPv4 Address]

    Specify the printer's IPv4 address and subnet mask.

    [Specify] [Machine IPv4 Address] Enter the IP address [OK] [Subnet Mask] Enter the subnet mask [OK] [OK]

  • [IPv4 Gateway Address]

    Specify the IPv4 gateway address for the printer.

    Enter the gateway address [OK]
PreviousNext