Before beginning to configure the printer, make sure that administrator authentication is properly configured under "Administrator Authentication Management".
Log in as the machine administrator from Web Image Monitor.
Point to [Device Management], and then click [Configuration].
Click [User Authentication Management] under "Device Settings".
Select [Basic Authentication] in the "User Authentication Management" list.
Select the "Printer Job Authentication" level.
For details about the printer job authentication levels, see Printer Job Authentication.
If you select [Entire] or [Simple (All)], proceed to Step 7.
If you select [Simple (Limitation)], proceed to Step 6.
Specify the range in which [Simple (Limitation)] is applied to "Printer Job Authentication".
You can specify the IP address range to which this setting is applied. Also, you can specify whether or not to apply the setting to the parallel and USB interfaces.
In "Available Functions", select the printer's functions you want to permit.
Click [OK].
Log out.
Log in as the machine administrator from the control panel.
Display the screen for configuring Basic authentication.
[System Settings] |
Display the screen for configuring Authentication Information.
[User Authentication Management] |
Select the functions you want to permit.
[Available Printer Functions] |
The functions you select here become the default Basic Authentication settings that will be assigned to all new users of the Address Book.
For details about specifying available functions for individuals or groups, see Limiting Available Functions.
Specify the level for printer job authentication.
[Printer Job Authentication] |
If you select [Simple (Limitation)], specify the range in which [Simple (Limitation)] is applied to "Printer Job Authentication". You can specify the IPv4 address range to which this setting is applied, and whether or not to apply the setting to the parallel and USB interfaces.
[Simple (Limitation)] |
For a description of the printer job authentication levels, see Printer Job Authentication.
Log out.
This can also be specified via Web Image Monitor. For details, see the procedure for SP C340DN.