Skip header
 

Cleaning the Registration Roller

When you use paper other than the standard types, specks of paper may stick on the registration roller, causing problems. Clean the registration roller if white dots appear on prints.

Clean the registration roller if printed paper becomes smeared after a paper jam is cleared.

CAUTION


  • The inside of the machine could be very hot. Do not touch the parts with a label indicating the "hot surface". Otherwise, an injury might occur.

Important

  • Do not use chemical cleaners or organic solvents such as thinners or benzine.

1Turn off the printer and unplug the power cord.

2Pull out the plug from the socket. Remove all the cables from the printer.

3Pull the front cover open lever, and then open the front cover with both hands carefully.

Printer illustration

The registration roller is set in the position shown by the illustration.

Printer illustration

Do not touch the registration roller.

Printer illustration

4Using a cloth, wipe the rubber registration roller.

Printer illustration

5Close the front cover with both hands carefully.

Printer illustration

6Firmly insert the plug of the power cord into the wall socket. Connect all the interface cables that were removed.

7Turn on the main power switch.