Duplex printing is selected as the default setting.
If you send a print job via USB 2.0 while the printer is in Sleep mode, an error message might appear when the print job is complete. In this case, check if the document was printed.
After creating a document, open the [Printing Preferences] dialog box in the document's native application.
For details, see Displaying the Printing Preferences dialog box in an application.
Make sure the [Setup] tab is selected.
Configure the following settings:
|
Click the [Paper] tab.
Configure the following settings:
|
Change any other print settings as necessary. For details, see the printer driver Help. |
You can set convenient print functions on the tabs of the printer driver. For details, see Convenient Print Functions. |
Click [OK].
Start printing from the application's [Print] dialog box.