Skip header
 

Receiving an IP address automatically (DHCP)

Follow the procedure below to set the printer to receive an IP address automatically using DHCP. The DHCP feature is active by default, so this procedure is only required if you have changed the default settings.

Important

  • When [Auto-Obtain (DHCP)] is selected, you cannot configure the IP address, subnet mask, or gateway address.

SP C340DN

Press the [Menu] key, and then select the setting items using the [Down arrow key] or [Up arrow key] key.

1Select [Host Interface] Press [OK]

2Select [Network] Press [OK]

3Select [Machine IPv4 Address] Press [OK]

4Select [Auto-Obtain (DHCP)] Press [OK]

You can check the detected addresses by pressing [IP Add.], [Subnet M], and [Gateway].

SP C342DN

1Press the [User Tools] key, and then display the [Network] screen.

[System Settings] [Interface Settings] [Network]

2Enable IPv4 protocol, and then specify the IPv4 address.

  • [Effective Protocol]

    Enable IPv4 protocol.

    Press [Active] under "IPv4" [OK]

  • [Machine IPv4 Address]

    Specify the printer's IPv4 address.

    [Auto-Obtain (DHCP)] [OK]