Skip header
 

Installing the IEEE 1284 interface board

This procedure is applied to SP C342DN only.

1Check the contents of the package.

2Turn the printer off and unplug the power cord.

3Remove the cable cover.

Rear side of the printer illustration

4Loosen the two screws and remove the slot cover.

Rear side of the printer illustration

The removed cover and screws will not be reused.

5Fully insert the IEEE 1284 interface board.

Rear side of the printer illustration

Check that the IEEE 1284 interface board is firmly connected to the controller board.

6Tighten the two screws to secure the interface board.

Rear side of the printer illustration

7Plug in the power cord, and then turn on the printer.

8Print the configuration page to confirm that the board was attached correctly.

Note

  • Check that the board was correctly installed by printing the configuration page. If it is correctly installed, "Parallel Interface" will appear for "Device Connection" on the configuration page. For details about printing the configuration page, see Test Printing.

  • If the board was not installed properly, repeat the procedure from the beginning. If it cannot be installed correctly even after trying the installation a second time, contact your sales or service representative.