Skip header
 

Removing prints from Finisher SR4080 during printing

This section describes how to suspend a large copy or print job when using Finisher SR4080.

Depending on the image you are copying or printing, prints might not stack properly. If this happens, suspend the job, remove the prints and then restart the job.

1Press the [Suspend / Resume] key.

Finisher illustration numbered callout illustration

  1. [Suspend / Resume] key

2Remove the stack of paper from the finisher shift tray.

Finisher illustration

3Press the [Suspend / Resume] key to restart the print.

Note

  • You can suspend copying or printing only when the finisher shift tray is selected as the output tray.