17. SP Command if Parameter None/0

Specify whether or not to eject paper when the "SP;" or "SP0;" command is received.

Eject Paper
Ejects the paper when one of these commands is received.
Do not Eject Paper
Waits for the next data even when one of these commands has been received.

Default: Eject Paper

"17. SP Command if Parameter None/0" is used to specify a pen number. Use this item to specify how the plotter behaves when the "17. SP Command if Parameter None/0" is accompanied by any parameter that specifies the pen number, or if No. 0 is specified.