Previous
This print setting is useful if the bottom edge of the drawing data appears cropped or faded when "43. Method to Auto Select Paper Tray" is set to "Org Sz Dtrmnd + R/E Ratio: Cor Valu" and "47. Method to Determine Original Size" is set to "Entire Image".
0: None
Printing is performed in the custom-sized length calculated according to the settings for the RPGL Menu.
1: Add 1 mm (Feed Direction)
Printing is performed for the length derived by adding 1 mm to the custom-sized length calculated according to the settings for the RPGL Menu. Using this function, you can prevent the bottom edge of the drawing data from being cropped due to the effect of unit conversion when the paper is the same size as the drawing data.
Default: 0: None
Selecting "1: Add 1 mm (Feed Direction)" increases the frame size, and it may affect the billing counter as a result.
When "1: Add 1 mm (Feed Direction)" is selected the value derived by adding 1 mm is printed as "Custom Size" in the Print Settings List (RPGL).
This function does not apply if the calculated length exceeds the maximum custom-sized length.
