Guide to Components

Front and left view

1. Original stacker

   Originals are stacked here.

2. Control panel

   See Guide to the Names and Functions of the Machine's Control Panel.

3. Scanner cover

   This protects the original feed mechanism and the scanning glass.

4. Front output auxiliary tray

   This can be used to receive the delivered copies.

5. Front Cover

   Open this cover to replace toner.

6. Main power switch

   To operate the machine, the main power switch must be on. If it is off, turn the switch on.

   See Turning On/Off the Power.

7. Earth Leakage Breaker

   To prevent electric shock this machine has an earth leakage breaker. The earth leakage breaker is normally in the on position.

   If the power does not come on, check if the earth leakage breaker is in the off position. If so, do not turn it to the on position.

   Contact your sales or service representative immediately.

8. Upper tray

   Stores Paper Roll 1 (foreside) and Paper Roll 2 (inner side).

9. Anti-condensation heater switch

   If condensation forms inside the machine as a result of temperature change, the machine may not print properly. To minimize this problem, use the anti-condensation heater.

10. [Scanner Stop] key

    Use if originals are feeding in slanted, or to cancel scanning while an original is feeding in. You can also use this to release the paper edge hold function.

11. Original table

    Place originals here scanning side up.

12. Original guide

    Set to the width of your originals.

13. Imaging unit release lever

    Use this lever to open the imaging unit when clearing paper jams inside or cleaning the machine.

    Do not leave the imaging unit open for 5 minutes or longer. Otherwise, copy quality may deteriorate.

    While holding down the imaging unit, pull the release lever to open it.

14. Bypass Tray

    Use to feed paper in manually. Load paper print side up.

15. Paper bypass's paper guide

    Set to the width of the paper for bypass copying.

16. Supply box

    Supplies can be placed here.

Rear and left view

1. Original exit

   Originals are delivered here.

2. Original output guide

   Stacks originals delivered to the rear output.

3. Fusing unit cover

   Protects the fusing unit.

4. Rear output

   Stacks copies delivered to the rear output.