Previous
When installing multiple options, the following order is recommended:
Attach the paper feed unit.
Attach the paper feed unit to the bottom of the printer.
You can attach up to three paper feed units. Up to 2,300 sheets of paper can be loaded.
If the paper feed unit is set on the floor, the tip-resistant caster table (option) is required for safe usage. The tip-resistant caster table can only be installed by a service representative. Contact your service representative for details.
Install the hard disk.
Install the optional interface board.
Install in the slot of the printer.
Only one interface board can be installed.
Insert SD card options.
Insert in the SD card slot of the printer.
There are two slots for SD cards.
Each slot supports different types of SD cards.
If you want to use two or more SD cards that can be inserted in the same slot, contact your sales or service representative.
