Storing stack memory mode settings

Press the [User Tools] key.

Use the [] or [] key to select [Initial Settings], and then press the [OK] key.

Use the [] or [] key to select [Program/Change Memory], and then press the [OK] key.

Use the [] or [] key to select a number, and then press the [OK] key.

If the number is already registered, a message will appear to ask if you want to overwrite the stored setting. To overwrite, press the [OK] key. Otherwise, press the [Escape] key to return to the previous display, and then select another number.

Use the number keys to enter the number of prints you want for each class, and then press the [] key.

Repeat Steps 4 and 5 to register all your classes.

Press the [OK] key.

Press the [Clear Modes/Energy Saver] key.

The contents that you have stored are now enabled.