Skip header
 

Saving Energy

If the machine is left idle for a certain period of time after printing, it will enter Energy Saver or Auto Off mode to reduce power consumption.

Energy Saver mode

The display goes off. Printing from a computer is possible in this mode. To operate the machine, press the [Clear Mode/Energy Saver] key, or place originals on the exposure glass or in the ADF.

To resume Energy Saver mode, press the [Clear Mode/Energy Saver] key.

Auto Off mode

The machine turns off automatically. To restart the machine again, turn on the main switch.

Note

  • You can specify which mode the machine enters after a specified period of time elapses after a job is complete. For details see [System].

  • You can change the time the machine waits before entering Energy Saver or Auto Off mode. For details see [System].

  • The machine will not automatically enter the Energy Saver or Auto Off mode if:

    • A warning message appears

    • There is no ink

    • A paper jam occurs

    • The machine is making a master or printing

    • The machine is printing the second page of a combine print

    • The master eject box is full

    • There is no master

    • Originals are left in the ADF

    • A cover is open

    • User Tools are being used to make changes

    • The user code entry screen is displayed

    • The Data In indicator is lit or blinking

    • A mode is being specified on the control panel

PreviousNext