Copies can be folded in the following ways: Z-fold, Half Fold, Letter Fold-out, Letter Fold-in, Double Parallel Fold, and Gate Fold.
You cannot use the following paper with this function:
Multi-folding unit
Letterhead
Transparencies
Tab stock
Translucent paper
Preprinted paper
High-gloss coated paper
Prepunched paper
Textured paper
Label paper (adhesive labels)
Envelopes
Magnet paper
Metallic/pearl paper
Clear file folder
Synthetic paper
Booklet Finisher SR5060
Transparencies
Tab stock
Translucent paper
High-gloss coated paper
Prepunched paper
Textured paper
Label paper (adhesive labels)
Envelopes
Magnet paper
Metallic/pearl paper
Clear file folder
Synthetic paper
Paper fed from the interposer can be folded.
Copying will stop if the number of copies exceeds tray capacity. If this happens, remove copies from the folding unit tray to resume copying. The finisher automatically ejects the maximum number of folded sheets to the finisher booklet tray.
The printed side of the paper may occasionally be scratched or stained with toner depending on the paper and the conditions of the machine's environment.
Print quality over fold lines might be reduced. This is due to cracking within the fused toner. Loss of surface along fold lines can also occur with some types of paper. To avoid possible wastage, print a single test sheet before beginning a print run.
The capacity of the folding unit tray or finisher tray may vary depending on the fold settings and the condition of the paper.
For details about which sizes and weights of paper that can be folded, see "Specifications", Maintenance and Specifications.
You can specify the fold-back position in [System Settings]. For details about how to adjust the fold-back position, see "General Features", Connecting the Machine/ System Settings.