Previous
Sizes of paper that can be fed from the multi bypass tray (Tray A) are as follows:
When the banner sheet tray of multi bypass tray (Tray A) is installed:
Horizontal length: 139.7–700.0 mm (5.50–27.55 inches), vertical length: 210.0–330.2 mm (8.27–13.00 inches)
When the banner sheet tray of multi bypass tray (Tray A) is not installed:
Horizontal length: 139.7–487.7 mm (5.50–19.20 inches), vertical length: 100.0–330.2 mm (3.94–13.00 inches)
Note however that the limitation on the horizontal and vertical length range will vary depending on which options are installed.
When prints are delivered to the upper tray of the finisher or the high capacity stacker:
Horizontal length: 139.7–700.0 mm (5.50–27.55 inches), vertical length: 100.0–330.2 mm (3.94–13.00 inches)
When prints are delivered to the shift tray of the finisher:
Horizontal length: 139.7–700.0 mm (5.50–27.55 inches), vertical length: 139.7–330.2 mm (5.50–13.00 inches)
When prints are delivered to the stacker tray:
Horizontal length: 139.7–487.7 mm (5.50–19.20 inches), vertical length: 139.7–330.2 mm (5.50–13.00 inches)
Load the paper face up in the multi bypass tray (Tray A).
Press [Tray A].
Make sure that [Paper Size] is selected.
Press [Program Custom Size].
Enter the horizontal size with the number keys, and then press [
].
Enter the vertical size with the number keys, and then press [].
Press [OK] twice.
Place the originals, and then press the [Start] key.
You can register a custom paper size. For details, see Registering a custom size. You can also recall the registered custom paper size. For details, see Recalling the registered custom size.
